Touch up any smudges and you will have a stylishly updated room instead of ugly, uneven, outdated walls. Mix your paint with glaze while you are waiting for your base coat to dry.Īpply your faux finish once your textured base coat is dry. After you get the texture on the walls you can add a faux finish to hide any remaining imperfections. Use the texture mix as a base coat for your room. When you get to that point you can mix up a gallon or half gallon, or however much you need for your size of room, and start painting. Start out adding just a little at a time and testing it on a scrap piece of wood or cardboard until you get to your desired level of texture. Experiment with the amount of texture you want. You don’t want to ruin a whole can of paint by dumping in too much texture. You will want to mix the paint and texture in a bucket or other container. It is also a lot cheaper to buy the additive than to buy actual texture paint. Coming in fine, medium and course levels of texture it gives you options. It comes in a box for around $4.00 with enough for at least 2 gallons of paint. It is a texture additive that could be added to regular latex paint. Use a texture paint additive like Paint N Tex by Homax. Get a couple sheets of poster board and several types of faux finish products like sponges, rollers, rags, or whatever else you want to try. Now you get to decide how you want to paint your walls.Įxperiment with faux finishes. If you use a product like Gripper, only one coat is needed. Let it dry and you are ready to prime.Īpply primer evenly with a roller. Wipe down the surface of the walls after you are done sanding with a damp cloth or large sponge to get off all the dirt and dust. The primer Gripper works well on any surface, it really sticks to it. So I roughed it up some more, and then used a primer called Gripper. I lightly sanded it and used Kilz primer. If you have a shiny or very smooth texture paneling you will want to sand it so it roughs up the surface really good. You will also need to lightly roughen up the walls if you have a high gloss paint that you are trying to cover. If you are covering paneling you will want to lightly sand the entire surface of the walls, you will also want to do this if you have wallpaper (if you don’t want to remove the wallpaper). Prepare the rest of the wall surface for primer once all your seams, holes, and dents are repaired. A small handheld electric sander can save you a lot of time and energy. If you go too far or you can still see the seams or dents, add another coat of putty or spackle and sand again. Do not go too far down or you’ll expose the seam lines, holes, and dents again. Sand the spackle down to the point where it is even with the rest of the wall surface. You don’t want to use a fine grain until the final sanding when you have things evened out. And do not use too fine a grain either because it won’t do anything. You don’t want it to rip off all the spackle. Use a mid grain sandpaper, not too course. You won’t want to sand it before it is completely dry. Let it dry for a day or at least overnight. Apply a good thick coat to all seams, dents, holes and any other imperfections. There are different formulas for wood, cement, concrete and drywall. Make sure you purchase a product that is made for the type of surface you are using it on. A good spackling paste that is for wood or masonry will work great on wood paneling. Start filling in all the seams and holes with a sandable putty or spackling paste.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |